PROPELLER SHAFT – Removal & Installation – Base,4WD To Rear Axle,Two Piece Propeller Shaft,Both – [Includes: Separate Front and Rear Shafts.] – [DOES NOT include removing Center Support Bearing from Front Shaft.]
Weld 17mm nut on front differential drain. Please make sure it can be loosened to service differential in the future.
Mike T. gave our service a 5 star review on 2/19/2020
Found disconnected vacuum line to fuel pressure regulator and dirty throttle body. Re-attached vacuum line and cleaned throttle body. Idle RPM now within specification.
Found poor connections at skid control module causing intermittent signal to right rear wheel speed sensor. Cleaned connector and signal now working properly.
Cameron A. gave our service a 5 star review on 2/18/2020